How to get the reset wire after controller firmware?

Question

Microcontrollers

Good afternoon! After I flash the controller (five wires), a problem arises. You need to get the reset wire. Apparently this is due to the fact that avrdude gives out a low level on all lines of the port. Because reset control on the controller is 0, the controller is permanently reset. It is not convenient to poke / stick the wire. I did not find a solution in the avrdude settings. Everything works great on Windows.

Answer 1

parameter -E noreset
www.nongnu.org/avrdude/user-manual/avrdude_4.html#...

Answer 2

toggle switch in wire break