How to create and configure VLANs in an enterprise?

C

Chaynik_zakipel2019-04-19 10:45:57

Computer networks

Chaynik_zakipel, 2019-04-19 10:45:57

Good afternoon. Tell me how to properly configure and set up Vlans in my case.
There is a configured network with Internet access from CISCO as well as several managed switches HP 2530-48 (2pcs) and 1910-25 at the moment, all equipment is in one single range, which is not very convenient and not safe.
Where to start setting up?
I would like to know the sequence of actions in this case.
The end result should be a picture that I depicted in the form of a diagram. All these subnets must be with Internet access and at the same time not see each other.

Reply

Answer the question

In order to leave comments, you need to log in

2 answer(s)

W

Wexter, 2019-04-19
@Wexter

https://linkmeup.ru/blog/13.html

D

Dmitry Shitskov, 2019-04-19
@Zarom

It is advisable to rely on the fact that on access switches you will have not only 1 vlan. Therefore, on access switches, you have access-vlan on ports towards the client, trunks towards core. Since your core L2, then towards the router is also a trunk with all vlan. If routing between vlan is necessary - it is necessary to resolve a router.