AVR SMD programmer?

Question

Electronics

Good, habr.
Here I set out to finally get off * duino, and also switch to smd. I'm trying to find a programmer for AVR SMD microcontrollers, but due to the lack of experience and a detailed understanding of the specifics, I get lost all the time and my eyes run wide. In this connection, I ask for help from the all-knowing Habr.
The device requires a small budget and the ability to flash atmega328. That's enough for me to start, I think.
Thanks in advance for the answers to the lamer question.
PS - a passing question to experts. Which SMD package is easier to start with?

Answer 1

For the programmer, it does not matter in which case the microcontroller is located. Each programmer maintains its own list of microcontrollers.
For your purposes, a usbasp programmer (or similar) is perfect, you can buy it in almost any (online) radio parts store or even make it yourself.
Offers on eBay.
Do it yourself.

Answer 2

what do you mean by SMD? If surface mount cases . That will go and the old arduino with the appropriate sketch. You just need to either buy an adapter (which is not cheap, about 149 €) or leave contacts on the board to connect to the controller via SPI.

Answer 3

I think it's more correct to provide for the possibility of programming directly on the board. Use SPI only you have to finish the circuit a little, because most often these ports cannot be left only for programming.

Answer 4

google: ftbb

Answer 5

easyelectronics.ru/skorostnoj-avr-usb-programmator-na-ft232rl-bez-vspomogatelnogo-kontrollera.html
do it yourself like this - in which case the controller is not important, the main thing is to output the debug outputs to the connector. Good luck

Answer 6

The controller can be pressed to the breadboard or DIP adapter with a clothespin. Connect to the programmer as fantasy tells.